The Philippi battery charger ACE 12/64 is a fanless 12V automatic charger for the onboard power systems of yachts, motorhomes, and off-road vehicles. It charges one battery or up to four battery banks simultaneously with up to 60 A.
- Charges up to four battery banks simultaneously, e.g., in systems with two engines as well as bow and stern thrusters.
- Fanless operation thanks to a heat sink integrated into the housing base – quiet, can also be installed in the engine compartment.
- Wide input voltage range of 90–265 V AC without power reduction – can be used worldwide, even with a weak shore power connection.
- Ignition protected according to ISO 8846, pluggable AC/DC connections, and temperature sensor included.
The Philippi ACE 12/64 is the most powerful 12V model in the ACE series and is designed for more complex onboard power systems with high charging current requirements. The control panel allows selection of the appropriate charging curve for wet, lead-calcium, GEL, and AGM batteries, as well as lithium battery systems; winter storage and power supply modes are also available. For connection to PSM and PSL system monitors, the optional ACE-T cable HPO is required.
In power supply mode, the ACE 12/64 provides a regulated and filtered DC power supply, for example, during the construction phase when no batteries are yet on board, or during a replacement phase.
| Feature | Value |
|---|---|
| Order No. (SKU) | 045126004 |
| Charging current | 60 A |
| Nominal voltage | 12 V |
| Outputs | 4 |
| Recommended battery capacity | 300–600 Ah |
| Charging curves | 4-stage, adjustable (factory setting 14.4 V / 13.8 V), winter storage, power supply mode, refresh function |
| Battery types | 7 charging programs for wet, lead-calcium, GEL, AGM batteries, and lithium battery systems |
| Input voltage AC | 90–265 V / 47–65 Hz |
| Efficiency | 90 % typical |
| Current consumption 230 / 115 V | 4.4 / 8.7 A |
| Dimensions L x W x H | 289 x 195 x 106 mm |
| Weight | 3.5 kg |
| Cooling | Fanless convection cooling |
| Operating temperature range | -20 °C to 60 °C, power reduced above 55 °C |
| Protection class | IP 22 |
| Electrical protection | Against short circuit and overvoltage (fuse) |
| Ignition protection | According to ISO 8846 |
| P-BUS connection | Optional via ACE-T cable HPO |
| Repairability index | 8.9/10 |
| Warranty | 3 years |
Compatibility: For P-BUS connection to Philippi system monitors PSM and PSL, the ACE-T cable HPO (Order No. 5 0411 1162) is additionally required. The ACE 12/64 belongs to the 12V series (ACE 12/30, 12/44, 12/64) alongside the 24V models ACE 24/25 and 24/30.
How many battery banks can the ACE 12/64 charge simultaneously?
Up to four separate battery banks, for example, in systems with two engines as well as bow and stern thrusters.
Is additional accessories needed for connection to the system monitor?
Yes, for P-BUS communication with the PSM and PSL system monitors, the ACE-T cable HPO is required and must be ordered separately.
Is the ACE 12/64 ignition protected?
Yes, the charger is ignition protected according to ISO 8846 and can therefore also be used in enclosed engine compartments.
Order the Philippi Battery Charger ACE 12/64 now – we will be happy to advise you on compatibility with your onboard power system.
⚠️Safety data sheet can be found under Downloads!
Downloads
Deutsche Downloads
