philippi Academy · Battery and storage

LiFePO4 in winter storage: how to store the battery correctly

5 min readBy Michael KögelLast reviewed

In short

A LiFePO4 battery is best stored over winter at 60 to 80 % charge, disconnected from the on-board network and checked at least every three months. It may only be charged when the cells are above 0 °C; a BullTron Polar heats itself with the charging current. In winter storage the danger is not the cold but deep discharge caused by standby currents.

Cold is not the problem, deep discharge is

A LiFePO4 battery copes well with frost in storage: BullTron specifies a storage temperature range of −20 °C to +60 °C for the Polar models, down to −30 °C for some. What makes winter storage risky is deep discharge. Three things draw current from the battery over the months:

  • Self-discharge: about 1 to 3 % per month according to the manufacturer.
  • Consumption of the battery management system (BMS): small but constant.
  • Standby currents in the on-board network: radio memory, alarm, bilge pump control, displays or leakage current caused by moisture.

If the cell voltage drops too far, the BMS switches the battery off to protect it. In spring it often cannot simply be recharged, and deep discharge can permanently damage the cells.

What state of charge for winter storage?

Store a LiFePO4 battery at 60 to 80 % charge. The sailing magazine YACHT recommends the same. This leaves enough reserve for self-discharge and standby currents without the battery sitting full for months. How quickly the reserve shrinks is shown by the example of a BullTron Polar 12 V 185 Ah over six months:

Assumption Loss in 6 months Remaining of 130 Ah (70 %)
self-discharge only, 1–3 % per month 11–33 Ah 97–119 Ah (52–64 %)
plus a standby current of 30 mA (0.72 Ah per day) around 130 Ah more empty, the BMS switches off

Even a small permanent load is enough to drain the battery over the winter. Disconnecting it from the on-board network is therefore the most important step.

Charging in frost: what the BullTron Polar heater does

Lithium cells must not be charged below 0 °C. The BMS of the BullTron Polar then blocks charging and diverts the incoming charging current into the built-in heater. According to the manual it heats up to 10 °C, and from a cell temperature of 1 °C the battery charges again. Without charging current the heater stays off and does not discharge the battery.

In practice this means a weak charger or a small solar panel may only be enough for the heater in frost, and the battery does not gain charge. Models without a heater, such as the BullTron starter batteries or the 12 V 100 Ah and 150 Ah with Bluetooth, should only be charged once the battery is above 0 °C.

Charger over the winter: leave it on or switch it off?

Both work. If you leave the charger connected, set it so that it does not keep the battery permanently full. BullTron specifies a float voltage of 13.5 to 13.8 V for the 12 V Polar models; YACHT recommends an even lower charge voltage of 13.0 to 13.2 V for winter storage, reset before the season. The philippi ACE battery charger has a lithium programme and a winter storage mode, and its charging curve can be set freely via the PSM or PSL system monitors. We are happy to advise by phone which setting suits your battery.

If you switch the charger off, check the battery at least every three months and recharge if necessary.

Remove the battery or leave it on board?

Removing it is not necessary as long as the battery is disconnected from the on-board network and you can check it. Removal makes sense if the boat stands without shore power over the winter, if you want to recharge the battery frost-free at home, or if it is unclear which loads still draw current. Mind the weight: a Polar 12 V 185 Ah weighs 16.4 kg, the large models up to 56 kg.

Checklist: winterising LiFePO4

  1. Fully charge the battery once. This recalibrates the state-of-charge display in the BMS.
  2. Discharge to 60 to 80 %, for example with the usual loads on board.
  3. Switch off all loads and open the battery main switch. Many Polar models also have an on/off switch on the housing.
  4. Check the standby current: if a battery shunt or the philippi Control Unit PCU still shows current with the main switch open, find the load.
  5. Switch the charger off or set it to a low storage voltage.
  6. Check voltage or state of charge every three months and recharge. In frost only with the Polar heater or when the battery is above 0 °C.
  7. Before the season, reset the charger and fully charge the battery.

Does this also apply to expedition vehicles?

Yes. Expedition vehicles often stand for months too, and control units or a tracker draw standby current from the house battery. Open the main switch, keep the state of charge between 60 and 80 % and check it regularly, and the lithium battery will come through the downtime without damage.

Further reading

Which parts belong to a switch to lithium is shown in the checklist From AGM to lithium; how to protect the alternator is explained in LiFePO4 on board: how to protect the alternator. All models with heater are listed under BullTron batteries; philippi is a certified BullTron dealer, and BullTron grants a 5-year manufacturer warranty on every BullTron battery. We answer questions in Remseck on +49 7146 8744-0.

Sources: BullTron Polar battery manual (German) and datasheets of the Polar models; YACHT, “Gefahr durch Kälte: So kommen Lithiumakkus gut durch den Winterschlaf”, 3 Feb 2026. As of 18 Nov 2026.

· Managing Director, philippi elektrische systeme GmbH

Michael Kögel is Managing Director of philippi elektrische systeme GmbH in Remseck am Neckar. Since 1978, the family-owned company has developed and manufactured on-board electrical systems for yachts, motorhomes and special vehicles.

Diplom-Ingenieur (Dipl.-Ing.), electrical engineering, with philippi for more than 35 years. Articles in the philippi Academy are written together with the engineering department and technically reviewed.

Published · Last reviewed

Frequently asked questions. Answered briefly.

What state of charge does a LiFePO4 battery need in winter storage?

Ideally 60 to 80 %. This leaves enough reserve for self-discharge, which for BullTron is about 1 to 3 % per month according to the manufacturer, and for the consumption of the BMS. At the same time the battery does not sit full for months. Disconnect it from the on-board network with the main switch and check the state of charge at least every three months.

Can I charge a LiFePO4 battery in frost?

Only when the cells are above 0 °C. The BullTron Polar handles this itself: below 0 °C the BMS blocks charging and diverts the charging current into the built-in heater, and from 1 °C the battery charges again. Batteries without a heater should only be charged once they are above 0 °C, for example after removal in a frost-free room.

Does the lithium battery have to be removed in winter?

No. According to the datasheet the BullTron Polar tolerates storage temperatures from −20 °C. What matters is that it is disconnected from the on-board network and that you can check the state of charge. Removing it is worthwhile if the boat stands without shore power, if you want to recharge frost-free, or if it is unclear which loads still draw current.

Technical

Your case isn't covered?
Ask us.

Our team knows every component and usually replies on the same working day, by email or by phone.

philippi tote bag and catalogue