Central connection point for sensors and on-board electronics
The Connect Hub is the central interface between sensors and display unit in the P-BUS system. Tank sensors, shunts and batteries are connected directly to the hub without tools – from there, only a single cable leads to the display. It significantly reduces wiring effort and installation time and is the recommended addition to the PCU Control Unit and the BTM2.
What the Connect Hub replaces
Instead of laying each sensor cable individually to the display, all connections converge at the Connect Hub. This minimizes sources of error during installation and makes the system clearer.
Functions at a glance
- Tool-free connection for tank sensors, shunts and batteries
- One cable to the display instead of individual wiring for each component
- Reliable signal transmission through central bundling
Compatibility
The Connect Hub is designed for use with the PCU Control Unit and also works with the BTM2: All sensors are bundled at the hub, and the display unit handles evaluation and control.
Areas of application
- Motorhome, camper & van: central sensor bundling for self-sufficient on-board electronics
- Boat & yacht: clean, reduced wiring on board
Technical data
| Feature | Value |
|---|---|
| Function | Central connection interface for sensors |
| Connection | tool-free, tank sensors/shunts/batteries |
| Dimensions | 100 x 100 x 30 mm |
| Cable length to display | 10 m |
| Compatible with | PCU Control Unit, BTM2 |
| Article number | 071009000 |
Frequently asked questions
What does the Connect Hub do? It bundles tank sensors, shunts and batteries at a central connection point – only one cable leads to the display.
Do I need tools for connection? No, the connection is tool-free.
Is the Connect Hub compatible with the PCU? Yes, it is designed for use with the PCU Control Unit.
Does the Connect Hub also work with the BTM2? Yes, the Connect Hub is also compatible with the BTM2.
How long is the cable to the display? 10 m.
⚠️Safety data sheet can be found under Downloads!
FAQ
Yes, this is possible. For this, the required fuse size per circuit must be specified when ordering the switch panel.
Yes, before each switchboard, a main fuse must be integrated into the supply line to the switchboard near the battery.
Yes, all common sensors used in the marine and automotive sectors can be connected.
