The TDS/TDN tank probes are suspended as immersion probes down to the bottom of a tank. Using the hydrostatic pressure of the liquid, the probe measures the current level in the tank. The PUR connection cable of the immersion probe contains a thin air hose for rear pressure equalization for the measuring cell. This automatically compensates for air pressure fluctuations and prevents measurement falsification.
The TDS/TDN immersion probes are suitable for (diesel), water, wastewater and faeces tanks, but not for petrol, kerosene, petroleum (EEx zone).
A mounting flange is included in the scope of delivery.
The pressure probes are used in conjunction with a:
. Tank monitor TCS / BTM / VTM
. Tank interface CMT 3 (system monitors PSM/PSL)
. Interface UTI (analogue (round) measuring instruments)
Application: Immersion probe
Construction: Immersion cable PUR black, length 2.5 m, oil-resistant
Probe housing: Stainless steel 1.4404 (316 L,V4A)
Tank media: Diesel, water, wastewater, faeces (TDS 200) Water, wastewater, faeces (TDN 200)
Measuring range: 0 – 200 mbar
Measuring resolution: 1 cm
Max. tank height: 200 cm
Operating temperature range: 0 – 40 °C
Dimensions: L 97, Ø 22 mm
Output signal: DC 4 – 20 mA, 2-wire principle
Operating voltage: 10 – 30 V DC via measuring cable
Weight: approx. 0.2 kg, without cable
⚠️Safety data sheet can be found under Downloads!
Downloads
Deutsche Downloads
FAQ
Yes, this is possible. For this, the required fuse size per circuit must be specified when ordering the switch panel.
Yes, before each switchboard, a main fuse must be integrated into the supply line to the switchboard near the battery.
Yes, all common sensors used in the marine and automotive sectors can be connected.
